Results for conrad components water level relay switch kit
For all liquid-level-controls, such as an automatic flower watering plant: By means of two electrodes (sheet strips, rust-free wire), which you simply insert in the ground of your flower bed or flower pot, the ohmic resistance of the garden ground or of the soil of the flowers is measured. When the...
Click For Info
This pre-assembled circuit inexpensively fulfils the functionality of a water level switch. When the water level reaches the switch\'s water sensor, the relay is activated, turning on a connected pump, alarm or valve.
Click For Info
Once constructed, this kit can be used to switch on 230V appliances such as a heater, heatpipes or similar when a set temperature is undershot. A KTY 81-220 temperature sensor (thermistor) determines temperature and the limits are set by the user via a trimpot. A separate trimpot can be used to...
Click For Info
Turns devices on and off at preset intervals. The timer range can be individually set from approx. 200 ms to 100 s with a potentiometer. An LED indicates when the switch has been actuated.
Click For Info
Kemo-M158-Water-Sensor-Relay-Switch-Module-9-12V-DC-Kemo-M158-P-This-module-has-a-very-sensitive-input-for-a-pair-of-probes-When-the-2-probes-come-into-contact-with-water-a-relay-switches-on-which-can-be-used-to-control-sirens-lights-pumps-etc-P-P-The-water-sensors-use-an-extremely-low-voltage-in-or...
Click For Info
When the 2 sensor connections come into contact with water, a relay is switched on. Thus sirens or pumps, etc. can be switched. Feature: The water sensors are charged with an extremely low voltage in order to prevent the otherwise usual oxidisation through galvanic currents.
Click For Info
Switches a relay when light or dark (shadow) is sensed. Whenever the light beam from a lamp projected onto doors, windows or similar is interrupted by a person, the device produces an alarm. Can also be used as a dimmer switch.
Click For Info
Acoustic continuity tester, especially for testing cables, conductor tracks and contacts. The advantage of this circuit is that soldered components don\'t have any effect on the measurements. An acoustic signal tells you when there\'s a short circuit.
Click For Info
The sensitivity adjustment to the attached sound source is achieved through variable negative-feedback. You can set the sensitivity to between approx. 10 and 600 mV.
Click For Info
Tamper-proof rotary switch 250 Vac 5 A Switch postions 2 1 x 90 ° Conrad Components LAS1-BGQ-22X/33 IP40 1 pc(s)
Click For Info
Tamper-proof rotary switch 250 Vac 5 A Switch postions 2 1 x 90 ° Conrad Components LAS1-BGQ-11X/23 IP40 1 pc(s)
Click For Info




























